8.Set the Console Assembly (91) on the Right Upright (54) and the Left Upright (not shown). Next, finger tighten four Handrail Bolts (3) with four Handrail Washers (13) and four Handrail Star Washers (10) (only two of each are shown) into the Right Upright and the Left Upright. Then, tighten all four Handrail Bolts.
Attach the Console Back (93) to the Console Assembly (91) with four Console Back Screws (7). Make sure that the Wire Harness (98) is in the indicated slot in the Console Back and that no wires are pinched.
9.Carefully lower the Handrails (55, 56) to the floor. Center the Frame (51) between the Handrails, and tighten the four Upright Bolts (2). Then, raise the Handrails back to the vertical position.
See the inset drawing. Attach the Latch Assembly (108) to the Left Upright (53) with two Latch Screws (7). Make sure that the Latch Assembly is oriented as shown.
8 |
|
|
|
91 | Slot |
|
|
54 |
|
|
|
|
|
| 7 |
98 |
|
| 93 |
|
|
| |
| 10 |
| 7 |
| 13 |
|
|
| 3 |
|
|
9 |
|
|
|
|
| 51 | 2 |
|
|
| |
|
| 55, 56 |
|
53
108
7
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 18). To protect the floor or carpet, place a mat under the treadmill.
9
