7.Attach the Left Pedal Arm (21) to the Left Upper Body Leg (6) with an M8 x 23mm Button Screw (65), an M8 Washer (64), and a Pedal Leg Cover (23).
Apply grease to a Large Wave Washer (20) and slide it onto the Left Crank Arm (42). Then, attach the Left Pedal Arm (21) to the Left Crank Arm with an M8 x 25mm Patch Screw (70) and an M8 Large Washer (81).
Repeat this step for the other side of the elliptical exerciser.
See step 3. Tighten the four M8 x 19mm Patch Screws (73).
8.The Console (10) requires four “AA” batteries (not included); alkaline batteries are recommended. Remove the battery cover from the Console. Insert four batteries into the Console; make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Then, reattach the battery cover.
7 |
|
|
|
| Grease |
6 | 73 |
|
23 |
|
|
64 |
|
|
65 | 21 | 81 20 42 |
| 70 | |
8 |
|
|
| Battery |
|
| Cover |
|
Batteries
10
9.While another person holds the Console (10) near the Upright (2), connect the Upper Wire Harness (18) to the wire harness on the Console.
Attach the Console (10) to the Upright (2) with four M4 x 16mm Screws (60). Be careful not to pinch the wire harnesses.
Attach the Water Bottle Holder (17) to the Upright
(2) with two M4 x 22mm Screws (66).
9
10
18
Wire Harness
2
60 
17
66
8
