ASSEMBLY
Assembly requires two persons. Place all parts of the exercise | cycle in a cleared area | and remove | the packing | |||
materials. Do not dispose of the packing materials | until assembly | is completed. | Assembly | requires | the includ- | |
ed tools and your own adjustable wrench _, | Phillips screwdriver | _ | _, | and | ||
pliers _.
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled.
|
|
| l\ |
M4 x 25mm Round | M8 Nylon | M8 Split | M8 Washer |
Head Screw | Locknut | Washer |
M6 x 15mm Button | M8 x 20mm | M8 x 55mm Button |
Screw | Button Screw | Screw |
MIO x 60mm Button
Screw
1.Slide the Rear Stabilizer (6) into the Frame (1). Attach the Rear Stabilizer with four M8 x 55mm
Button Screws (30).
i i
2.Orient the Front Stabilizer (2) with the large holes
facing the Frame (1). Attach the Front Stabilizer to the Frame with two M10 x 60mm Button
Screws (33).
6
30
33
Large
