Weslo WLTL19205.2

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 9.

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be-

come damaged. Remove the key and UNPLUG THE

POWER CORD.Using the allen wrench, turn both

rear roller bolts counterclockwise, 1/4 of a turn. When

the walking belt is properly tightened, you should be

able to lift each edge of the walking belt 2 to 3 inches

off the walking platform. Be careful to keep the walk-

ing belt centered. Then, plug in the power cord, insert

the key, and run the treadmill for a few minutes.

Repeat until the walking belt is properly tightened.

c. If the walking belt still slows when walked on, see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt has shifted to the left, first re-

move the key and UNPLUG THE POWER CORD.

Using the allen wrench, turn the left rear roller bolt

clockwise 1/2 of a turn. Be careful not to overtighten

the walking belt. If the walking belt has shifted to

the right, turn the left rear roller bolt counterclockwise

1/2 of a turn. Then, plug in the power cord, insert the

key, and run the treadmill for a few minutes. Repeat

until the walking belt is centered.

SOLUTION: a. If the walking belt slips when walked on, first remove

the key and UNPLUG THE POWER CORD.Using

the allen wrench, turn both rear roller bolts clockwise,

1/4 of a turn. When the walking belt is correctly tight-

ened, you should be able to lift each edge of the walk-

ing belt 3 to 4 inches off the walking platform. Be

careful to keep the walking belt centered. Then, plug

in the power cord, insert the key, and carefully walk

on the treadmill for a few minutes. Repeat until the

walking belt is properly tightened.

2”–3”

Rear Roller

Bolts