Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small

parts used in assembly. Assembly requires your own phillips screwdriver , two adjustable

wrenches , and scissors .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

	1/4Ó x 1Ó Bolt (23)Ð4	1 1/4Ó Screw (20)Ð4
3/8Ó Nut (34)Ð4	1/4Ó x 1Ó Bolt (23)Ð4
3/8Ó Nut (34)Ð4
		Screw (24)Ð4
Handrail Washer (51)Ð4	3/8" Washer (44)Ð4	3/8Ó x 2" Bolt (43)Ð4

1.With the help of a second person, carefully raise the Uprights (31) to the position shown. Note that the Console Base (12) and the Right Handrail (32) are joined to the right Upright with the Wire Harness (28); be careful not to pull on the Wire Harness. Set the Right Handrail on the right Upright until step 3 is completed.

Refer to the inset drawing. Position one of the Base Legs (38) against the base of the right Upright (31) as shown. Make sure that the Base Leg Pads (41) and the Front Wheel (39) are in the indicated positions. Attach the Base Leg with two 3/8Ó x 2Ó Bolts (43), two 3/8Ó Washers (44), and two 3/8Ó Nuts (34).

Attach the other Base Leg (41) in the same way.

2.Without removing the tape from the Latch (18), attach the Latch to the left Upright (31) with the four Screws (24). Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape.

Note: The inset drawing shows how the parts of the Latch (18) fit together.