Weslo WLTL25582 user manual Tighten all four Handrail Bolts 77 as tightly as

3. Insert the Wire Harness (53) into the right Upright	3			45
(37) as you press the Console Base (45) onto both
Uprights. Insert two Handrail Bolts (77) through each
side of the Console Base and through the Uprights	41			41
as shown. The Handrail Bolts must be inserted
from the inside as shown. Tighten a Handrail Nut
(41) with a Handrail Washer (39) onto each Handrail		77		39
Bolt.				77
	39
				53
			37
Tighten all four Handrail Bolts (77) as tightly as		Handrails		45
possible. Carefully lift up and push down on the
handrails to make sure that the Console Base
(45) does not move. Regularly inspect and tight-
en all four Handrail Bolts.
		77		77
			37
4. Attach the Frame Guide (66) to the left side of the	4
Frame (21) with two Frame Guide Screws (44) as
shown. Be careful not to overtighten the Screws.
Make sure that the thick end of the Frame Guide
is at the bottom.
	44	66
		Thick end		21
5. Remove the backing from the Adhesive Clip (2).	5
Press the Adhesive Clip onto the base of the Upright
(37) in the indicated location. Press the Allen
Wrench (35) into the Adhesive Clip.				37
				2
				35
6. The Console (49) requires two "AA" batteries (not	6
included); alkaline batteries are recommended.		49
			48
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the nega-
tive (Ð) ends of the batteries touching the springs.
Close the battery cover, push up on the battery cover	Batteries			Tab
tab, and then push the tab forward as shown in the
inset drawing. Be sure that the tab locks into place.

7.Make sure that all parts are properly tightened before you use the treadmill. The use of the remaining parts will be described in other sections of this manual. To protect the floor or carpet from damage, place a mat under the treadmill.

6