Weslo WLTL39092 Diagram of the Console, Battery Installation, Step by Step Console Operation

DIAGRAM OF THE CONSOLE

	Speed Control		Monitor Display
Clip	Key	Pulse Sensor		Incline Control

CAUTION: Before operating the console, read the following precautions.

•Do not stand on the walking belt when turning on the power.

•Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.

•Adjust the speed in small increments.

•The training zones marked around the speed control are general guidelines only. See page 14 or more information.

•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.

BATTERY INSTALLATION

The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. To in- stall batteries, open the battery cover as shown below. Press two batteries into the battery compartment, with the negative (–) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Be sure that the tab locks into place.

	Battery Cover
Batteries	Battery
	Cover Tab

STEP BY STEP CONSOLE OPERATION

Step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the steps below and on page 9 to operate the console.

1 Insert the key fully into the power switch.

Note: Inserting the key

will not turn on the dis- play. The display will

turn on when the ON/RESET button is pressed or when the

walking belt is started. (If you just installed

batteries, the display will already be on.)

8