Monitor Display |
Speed Control |
Clip |
Note: If there is a thin sheet of clear plastic on the face of the console, remove it.
Key | Pulse | Incline |
| Sensor | Control |
CAUTION: Before operating the console, read the following precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip (see the drawing above) while operating the treadmill. When the key is removed from the console, the walking belt will stop.
•Adjust the speed in small increments.
•The training zones marked around the speed control are general guidelines only. See page 14 or more information.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealable water bottle.
BATTERY INSTALLATION
The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. To install batteries, open the battery cover as shown below. Press two batteries into the console, with the negative
(–)ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Be sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothes. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed. Follow the steps below and on page 9 to operate the console.
Battery Cover |
Tab |
Batteries |
1 Insert the key fully into the power switch.
Inserting the key will not turn on the display.
The display will turn on when the ON/RESET
button is pressed or when the walking belt
is started. (If you just
installed batteries, the display will already be on.)
8
