7. Set the console assembly face down on a soft | 7 |
|
|
surface to avoid scratching it. Hold a Handrail |
|
| |
|
|
| |
(18) near the console assembly. |
|
|
|
Next, insert the console wire into the hole in the | Console |
|
|
bottom of the Handrail (18) and out of the indi- | Wire | 22 |
|
cated square hole. If necessary, grip the con- | 18 |
| |
| 21 | 2 | |
nector with needlenose pliers only in the area |
| ||
|
| ||
indicated by the arrow (see the inset drawing.) |
|
|
|
Then, attach the ground wire to the Handrail with | Square |
|
|
a Silver Ground Screw (11). |
|
| |
Hole |
| Ground | |
|
| ||
Next, set the Handrail (18) on the console as- |
|
| Wire |
sembly. Make sure that no wires are pinched. | Console |
| 11 |
Finger tighten a Console Bolt (22) with a 1/4" | Assembly |
|
|
Star Washer (21) into the Handrail, and then |
|
|
|
start two 3/4" Screws (2) into the Handrail. |
|
|
|
Tighten the Console Bolt and then the two |
|
|
|
Screws; do not overtighten the Screws. |
|
|
|
Attach the other Handrail (not shown) to the con- |
|
|
|
sole assembly in the same way. Note: There are |
|
|
|
no wires on the other side. |
|
|
|
8. Insert the Upright Wire (28) through a Handrail | 8 |
|
|
Spacer (88) as shown. Attach the Handrail |
|
| |
| 88 |
| |
Spacer to the Right Upright (36) with a 3/4" |
|
| |
Screw (2). |
|
|
|
Attach the other Handrail Spacer (not shown) to | 2 |
|
|
|
|
| |
the Left Upright (not shown) as described above. | 28 |
|
|
Note: There is not a wire on the left side. |
|
| 36 |
|
|
| |
9. While another person holds the Console Base | 9 |
|
|
(26) near the right Handrail (18). Connect the |
|
| |
|
|
| |
console wire to the Upright Wire (28) as shown |
|
|
|
in the inset drawing. Important: If the connec- |
|
|
|
tors are oriented correctly, they will slide to- | 18 |
|
|
gether easily and snap into place. If the con- |
|
| |
nectors are not oriented correctly, the con- |
|
| 26 |
sole may be damaged when the power is |
|
| |
turned on. Insert the connectors into the Right | 36 | Console Wire | |
Upright (36). |
| ||
|
|
| |
Attach the Console Base (26) to the Right |
| 28 |
|
|
|
| |
Upright (36) and the Left Upright (not shown) | 19 |
|
|
with four Handrail Bolts (20) and four Handrail |
|
|
|
Star Washers (19) (only one side is shown). | 20 |
| 28 |
Start all four Handrail Bolts before tightening |
| ||
any of them. | 19 |
|
|
|
|
| |
| 20 |
|
|
| 9 |
|
|
