5. While a second person holds the console as-

 

 

 

 

5

 

sembly near the Handrail (20), attach the

 

 

 

 

 

ground wire to the indicated hole in the Handrail

 

 

 

 

 

 

with a Ground Screw (33).

 

 

 

 

 

 

Ground

 

 

 

 

Wire

 

 

 

 

33

 

 

 

 

Hole

 

 

 

 

20

 

 

 

 

 

Console

 

 

 

 

Assembly

6. While the second person continues to hold the

6

 

 

 

console assembly, locate the wire underneath

 

 

 

 

 

 

 

the console assembly.

 

 

 

 

Connect the wire from the console assembly to

 

 

 

 

the Wire Harness (77). See the inset drawing.

 

 

 

 

The connectors should slide together easily

 

 

Wire

77

and snap into place. If the connectors do not

 

 

 

 

slide together easily and snap into place, turn

 

 

 

 

one connector and then try again. IF THE CON-

 

 

 

 

NECTORS ARE NOT CONNECTED PROP-

Console

77

 

 

ERLY, THE CONSOLE MAY BE DAMAGED

 

 

WHEN THE POWER IS TURNED ON. Insert

Assembly

 

 

 

the connectors downward into the Handrail (20).

 

 

 

 

 

 

20

 

 

7. Set the console assembly on the Handrail (20).

7

 

 

 

Be careful to avoid pinching any of the

 

Console Assembly

 

 

 

 

wires. Make sure that the ground wire (see

Channel

 

 

 

step 5) and the wire from the console assem-

 

 

 

 

 

 

 

bly (see step 6) are in the indicated channel.

 

 

 

 

Hand tighten five Screws (3) into the Handrail

 

 

 

 

(20) and the console assembly. Do not put

 

 

 

 

Screws into the two indicated holes. Start all

 

 

 

 

five Screws, but do not tighten them yet.

 

 

 

 

 

 

 

20

 

 

 

3

3

3

 

 

 

 

 

 

No Screws

 

 

8

 

 

 

Page 8
Image 8
Weslo WLTL49907.0 user manual Nectors are not Connected Prop, ERLY, the Console MAY be Damaged