WESTERN DIGITAL HARD DRIVE
DATA LIFEGUARD INSTALL SOFTWARE - 18
INSTALLATION GUIDE
B. Drive to Drive Copy
1. Select the Drive to Drive Copy from the main menu and click Next to proceed.
2. Select from two methods of copy on the destination drive with either Entire Drive or
Selective Partition. Click Next.
3. Select the source drive (the drive that you want to copy from).
4. Select the destination drive (the drive that you want to copy to).
5. Click Next to continue with drive to drive copy.
C. Advanced Options
1. Select Advanced Options from the main menu and click Ne xt to proceed.
2. The menu will appear and you will be given three options.
-Select EZ-BIOS Setup to configure EZ-BIOS settings for a drive. Simply highlight the
drive and click on either Uninstall EZ-BIOS or EZ-BIOS Settings.
-Select Backup/Restore Track Zero to restore the boot track 0 if damaged. Track 0
contains the partition table and boot code. A backup is automatically made when Data
Lifeguard is used to set up your drive.
-Select Remove 63 Sector Offset to remove Disk Manager data offset by 63 sectors. If the
Disk Manager boot codes exists, it is removed also.
3. Click Done after selection to return to the main menu.
IMPORTANT: Backup/Restore Track Zero and Remove 63 Sector Offset
options are for advanced users only. Consult with Western Digital Technical
Support for more information.