1.Introduction
This Quick Start Guide describes the installation procedure for the PTS series hardware. The PTS is essentially a power fallback switch, that automatically switches power from a primary input to a secondary input when power to the primary input is lost or interrupted.
2.Hardware Installation
Apply Power to the MPC
Refer to the warnings and cautions at the beginning of this guide and the power rating nameplate on the PTS back panel, and then connect the unit to two appropriate power sources. For units with detachable power input cables, connect the power input cables to the power inlets, install the cable keepers, and then connect the primary power input cable to your primary power supply and the secondary power input cable to your secondary power supply. Refer to the table below for information concerning power requirements and maximum loads.
| Input | Input | Max. Load |
| Max. Load |
Model No. | Feeds (x2) | Voltage | per Outlet | Outlets | per Unit |
15 Amps | 100 to 120 VAC | 12 Amps | 8 ea. NEMA | 12 Amps* | |
20 Amps | 200 to 240 VAC | 10/16 Amps | 8 ea. | 16 Amps* | |
|
|
|
| 1 ea. |
|
* In accordance with UL requirements, this value has been
Power Input Feeds:
•
•
Notes:
•After connecting your power cables to the PTS unit, make certain to secure the cables in order to prevent accidental disconnection.
•
•