MOUNTING AND WIRING INSTRUCTIONS
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures meet all UL specifications.
1.Turn off power at circuit box to avoid possible electric shock.
2.Thread mounting screws (A) into universal mounting plate or cross bar (B) approximately 1/4 inch (see fig. 1).
3.Secure universal mounting plate or cross bar (B) to outlet box (C) with outlet box screws (D).
4.Select number of stems (E) to install based on desired fixture length, then connect stems (E).
5.Thread fixture wires up through stem(s) (E) and through coupling (F).
6.Thread stem(s) (E) into coupling (F) and into socket assembly (G).
7.Identify color coding of fixture wires (see fig. 2).
8.To connect wires, take black fixture wire (group A from fig. 2) and place evenly against black outlet box wire. Do not twist wires.
9.Fit wire connector (H from fig. 1) over wires and twist until there is a firm connection. If
wire connector (H) easily comes off, reattach and check again for a firm connection (see fig. 2).
10.Repeat steps 8 and 9 with the white (group B from fig. 2) fixture wires and outlet box wires.
11.Partially thread green grounding screw (I) into side hole (J) on universal mounting plate or cross bar (B) (see fig. 1).
12.Wrap ground wire from fixture around green grounding screw (I) leaving enough excess wire to then connect ground wire and outlet box wire with wire connector (H), if applicable.
13.Tighten green grounding screw (I). Do not over tighten.
14.Tuck wires inside outlet box (C).
FIXTURE ASSEMBLY INSTRUCTIONS
Warning: This fixture is for indoor use only.
1.Raise canopy (K) to ceiling allowing mounting screws (A) to protrude through openings in canopy (K) and secure into place with cap nuts (L) (see fig. 1).
2.Place decorative ring (N) over glass shade (M), if applicable.
3.Raise glass shade (M) up to socket assembly (G) and secure with retaining ring (O).
4.Install lamp(s). Do not exceed recommended wattage.
5.Turn power back on at circuit box.
4
