INSTALLATION INSTRUCTIONS
BUILT-IN INSTALLATION
If you specifi ed a
CUTOUT FOR BUILT-IN
Installation Location
-This dishwasher is approved for
-Air space requirements: Sides=3/16” (.48 cm),
-The water inlet hose from the machine terminates in a 3/4” “female” connector. The water supply should there- fore terminate in a similar “male” connector and should have a stopcock close by in the pipe.
-Make sure the HOT water supply faucet connection is within easy reach of the machine. The fi
Water Drainage
Water
Supply
Min.
Opening:
|
|
| Water |
| |||||
|
|
| Inlet |
|
| Min. | |||
|
|
|
| ||||||
Water |
|
| |||||||
Outlet |
|
| |||||||
Electrical |
|
| Deep | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Opening: Min. 23" Wide
-Standpipe Drain System: No point of the drain hose must ever be placed higher than the top of the machine. If this should ever happen, the functioning of the machine can be affected.
-Sink Drainpipe System: When routing the drain hose through cabinets or walls, use a protective material such as electrical or duct tape to cover sharp edges that could damage the drain hose. Use a suitable clamp to se- cure the drain hose to the “Y” branch or disposer. With a sink drainpipe system, you may connect directly: 1) To a disposer by following the manufacturers attachment method. 2) directly to a “Y” branch tailpiece (available at most hardware stores).
TRIM KIT DIMENSIONS
| Width: 25 1/8” |
|
17 3/8” |
| 20 1/2” |
Height: | Width: 22 5/8” | Height: |
|
|
|
|
(side view) | Trim Kit |
DrainDishwasher
Connection
Installation Block
| Supply |
| Connection |
WATER DRAINAGE OPTIONS | |
Outlet | Sink |
Hose Hanger | |
| Sink Drain W/ "Y" Branch Tailpiece |
Standpipe | Floor Standpipe Drain |
|
4