Whirlpool 1157672 If your air conditioner is Not operating properly, If you need assistance

4 Insert the frame in the wall n opening, Square and level

frame. Nail frame securely to the wall studs.

7 Place level on air

n conditioner in openinq. There should be a tilt t6 the - outside of about one bubble. The air conditioner should be level from side to side.

air conditioner

K Remove air conditioner and ti l front panel from carton.

fram<.

1 Remove the rear grille from n the air conditioner and

discard the grille. ~;--~

cabinet flange

Place the foamseal between the front edge of the air conditioner base and the bottom flange of the cabinet.

Personal Injury/Product

Damage Hazard

l Maintain a firm hold on the air conditioner to prevent it from falling out of the opening -during installation.

Failure to follow this instruction could result in personal injury or damage to the air conditioner.

air conditioner

frameT

6 Place unit in center

. of opening.

Wall/Floor Damage

Check that air conditioner is tilted to the outside so that water will run to the outside.

Failure to do so may cause damage to wall/floor coverings.

Secure air conditioner in

8n opening. Go to Step 9.

tab

tront panel

screw

lik

9 Remove sheet metal n screws from front base

flange. Insert tabs on the top

edge of front panel into slots in the air conditioner cabinet. Use two screws to attach the bottom of the front panel to the cabinet.

10 Use insulation to seal n opening between

cabinet and frame. Caulk outside wall openings around cabinet.

11 If needed, install n moldina around

room side of cabinet.

2 Install the sleeve by

n following the installation instructions that came with it.

3 Follow THROUGH-THE-WALL n INSTALLATION, Steps 9

through 11 to complete installa- tion.

If your air conditioner is

not operating properly...

Check that the circuit breaker is not tripped or house fuse blown. Check that power supply cord is securely plugged into the electrical outlet.

If you need assistance...

The Whirlpool Consumer Assistance Center will answer any questions about operating or maintaining

your air conditioner not covered in the Installation Instructions. The Whirlpool Consumer Assistance Center is open 24 hours u day, 7 days a week. Just dial (800) 253-l 301 -the call is free. When you call, you will need the air conditioner model number and serial number. Both numbers are found on model and serial label located behind the front panel on the base flange.

Pcirt No.	1157672	Rev. D	Prepared	by Whirlpool		Corporation,		Printed in U.S.A.
t’ 1902	Whirlpool	CorL>cJrcJtiorl	Benton	Harbor,	Michigan		49022