Whirlpool 2183013 warranty Connecting to refrigerator, Reconnect electrical supply to refrigerator

Connecting to refrigerator

1.(On kit models, assemble water valve to refrigerator per kit instructions.) Route the copper tubing through the tube clamp provided as shown at right. Connect the X-inch copper tube from the shut-off valve to the water valve at the lower, left rear of cabinet. Remove tape label from valve inlet and insert tubing until it bottoms out. (Approximately l/2 inch.) Tighten nut by hand as much as possible; then turn the nut an additional l/2 turn using a wrench. Do not over tighten.

2.Turn shut-off valve ON. CHECK FOR LEAKS. TIGHTEN ANY CONNECTIONS (INCLUDING CONNECTIONS AT THE VALVE) OR NUTS THAT LEAK.

3.The ice maker is equipped with a built-in water strainer. If local water conditions require periodic cleaning or a well is your source of water supply, a second water strainer should be installed in the S-inch water line. Obtain a water strainer from your nearest appliance dealer. Install at either tube connection.

4.Reconnect electrical supply to refrigerator.

Use only %-Inch copper tublng from cold water llne

*Tube clamp

13