OPERATING YOUR WASHER

What happens in each cycle

When the Cycle Control Knob is set to a number and pulled out, the washer fills (to the selected load size) before agitation and timing start. The washer will begin agitating immedi- ately after filling; agitation can occur with the washer lid up or down. After agitation starts, the Cycle Control Knob turns clockwise until it points to an OFF area and the cycle ends.

NOTE: A Gentle Wash system helps protect your fabrics by reducing wash agitation speed during the last few minutes of wash agitation in the REGULAR and PERMA- NENT PRESS cycles.

WASH

Fill

Wash selected time

Drain (or partial drain)

No agitation

The Permanent Press cycle partially drains, fills, agitates briefly, and drains.

Spin

RINSE

Fill

Rinse

Drain-No agitation

Spin-Spray rinse

Spin

Off

MAGIC CLEAN* lint filter

The lint filter at the bottom of the washer basket cleans itself. During agitation, wash and rinse water pass over the filter, separat- ing the lint from the water. The lint is then spun away from the filter and out of the system during the spin part of the cycle.

If your washer drains into a tub, remove any lint collected in the tub or strainer.

MAGIC CLEAN

Basket

lint filter

interior

8

Page 8
Image 8
Whirlpool 2LSR5233BN0 manual What happens in each cycle, Magic CLEAN* lint filter, Wash, Rinse