If local codes permit connection of the frame ground- ing conductor to the neutral (white wire), connect the green and white wire from the supply cable of the appliance together and to the neutral (white) wire in the junction box. Connect the remaining wires from the supply cable. matching the colors, to the wires in the junction box.
If local codes DO NOT permit frame grounding to the neutral, separate the white and green wires that extend out of the end of the supply cable of the appliance. Connect the white wire from the supply cable to the neutral wire In the junction box.
Connect the black and red wire from the supply cable. matching the colors, to the corresponding wires in the lunchon box. The green wire MUST now be used to ground the appliance In accordance wtth local electri- cal codes Connect the green ground wire to a grounded cold water plpe*or to the grounded lead in the service panel Do not ground to a gas supply pipe. DC not connect to electrlcal power supply until
appliance IS permanently grounded. Connect the ground wire before turning on the power See ffgure 2
| GROUNOEO COLD |
COPPER | WATER PIPE |
GROUND WIRE | (REMOVE PAINT, ETC.) |
GROUND CLAMP (MUST BE TIGHT ON PIPE)
FIGURE 2
*Cold water pipe must have metal continuity to electrical ground and not be Interrupted by plastic, rubber or other electrically insulating connectors (including water meter or pcimp) without adding a jumper wire at these connec- tions.
CAU rlON - If connecting to a
3. INSTALLATION
NOTE:
Before installing the oven in the cutout, it may be helpful to remove the oven door. See details below.
Insert appliance into
The mounting holes in the front frame of appliance may be used as a template to locate the ap- pliance mounting screw holes.
CAUTION: For your personal safety, and to minimize potential personal injury, this oven must be securely fastened to the cabinet, using the four screws that are provided.
Use caution when mounting oven in cutout so you do not overtighten screws and cause porcelain chippage or puncture oven cavity.
TO REMOVE OVEN
View a | View b |
Open door fully.
Swing the 2 clips located on door in front of hinges so they cross over the hinge slots (View a).
Close the oven door slowly until you feel it stop.
Lift up slightly allowing the bottom of the door to swing out. (View b) Note that the top of the door must be tilted toward the oven at this point to allow hing arms to swing free. if appliance is so located that you cannot grasp both sides of door you may grasp the door by handle (View c) and follow same procedure outlined above.
TO REPLACE OVEN DOOR
1.Grasp door by sides (View b) or by handle and align hinge arms on door with TOP of slot in oven sides.
2.Tilt top of door toward the oven (View b) and allow door to “ride” into position. A slight lifting and inward pressure toward the bottom of the door will make sure it seats pro- perly. (View d).
3.Open door fully and swing the clips away from the slots (View a).
