I
I_

I’

s

Before you start...

Check location where washer
will be used Proper installation for
operation
IS your responsibility
Make sure you have everything
necessary for correct operation
Untape and open washer Ild.
/ Remove packages from washer,
Do not remove combination hose
I or release shipping straps at this
I time. Close and retape lid.
Grounded electrical outlet
is required See ElectrIcal
Hot and cold single-spout water
faucet:
Must be accessible within
4 feet of back of washer and
provide 5-100 PSI water pressure,
Water Heater:
Set
dater ?a washer. deilver 1
to
Protection from weather:
Do not
store sr operate washer below
32 F See Use and Care Guide for
fbriher :-formation
Sink or laundry tub: VJ :i-
minimum carry-away capac,-1 c’
7 gallons per minute to dra,’
washer Top of sink or iti9 irclst KIT
at least 27 inches high and no
i-:gher +har-I 48 Inches fror^, oo+torr
SEE RECESSED AREA
INSTRUCTIONS ON
BACK COVER.
Support: Floor must be S:K
enougn To support washer AE Jht
of
250 pounds.
\
Important: Observe all governing
codes and ordinances. Level floor:
maxlmurr? f’vzr SIOc?
under entire washer -irlck

Electrical

Tools needed for

installation: requirements

120
volt, 60 Hz, AC only, 15 or 20 ampere
fused electrical supply is required.
(Time-delay fuse or circuit breaker is
recommended.) It is recommended that
a separate circuit serving only this
appliance be provided.
receptacle is not available, it is the
personal responsibility and
obligation of the customer to have
a properly grounded 3-prong wall
receptacle installed by a qualified
electrician.
3-prong grounding
type wall
receptacle
Electrical Shock Hazard
l
Check with a qualified electrician if You
are in doubt as to whether the appliance
is properly grounded. Do Not modify the
power supply cord plug - if it will not fit the
outlet, have a proper outlet installed by a
qualified electrician. Improper connection
of the equipment-grounding conductor
can resull in a risk of electrical shock.
l
Do Not use an extension cord with this
appliance. Such use may result in a fire,
electrical shock or other personal injury.
0 Do Not have a fuse in the neutral or
grounding circuit. This could result in a
risk of electrical shock.
3-prong
grounding

Parts supplied

for installation:

Remove parts from packages. Check
that all parts were included.
Po\wer
SUPPlY
cord
Grounding
prow

Recommended

grounding

method

Figure 1
Do Not, under any circumstances,
remove the power supply cord
grounding prong.
For your personal safety, this appliance
must be grounded, This appliance is
equipped with a power supply cord
having a 3-prong grounding plug. To
minimize possible shock hazard, the
cord must be plugged into a mating 3-
prong grounding type wall receptacle,
grounded in accordance with National
Electrical Code, ANSVNFPA 70-1987
(or to the latest) and local codes and
ordinances. See Figure 1. If a mating wall
1 literature 2 rear casters
package 1 hose clamp
2 front casters 1 faucet adapter kit
PANEL A