Whirlpool 3354199 installation instructions Groundingmethod, YiiiiT’mer \ ‘5 \ .a, PAGE4

level, screw the front legs up or down to adjust. Make final check with level.

When washer is level, use wrench to turn nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate.

On coirroperated washers, remove the service door of the meter case. Lift the service door up at the back and remove. Carefully insert coin slide with the coin slide extension attached into front opening and secure with the %” mounting bolt from inside the meter case. The coin slide may need to be partially pushed in to insert mechanism

in the front opening. Replace meter case top and service door. Insert coin vault with lock and key.

19 Check that all parts are w now installed. See parts

list, Page 2. If there is an extra part, go back through steps to see which step was skipped.

20 Turn on water faucets W and check for leaks.

Tighten couplings if there is leaking

Untape electrical cord

21 and plug into

’ grounded outlet.

			Rotate	counter-
			clockwise	only
lm	. ‘3 \			‘6
	0	I	:_ lit&		“off”
			w posltlon
	+		Timer		Wont

l Coin-operated timers can be started by turning the clutch assembly counter-clockwise until the washer starts to fill with water.

-II

Pull to start

Push to stoa-

I

Timer-rearview

l Non-coin operated timer cycle information is ink stamped on the rear of the timer. Push in on the lever attached to the timer shaft. Reset lever to the Normal cycle position then pull out on lever to start washer.

17 Put the coin vault with lock n and key in the meter case opening. A larger capacity coin vault can be installed. Use a knife to carefully

remove the paint along the seam at the bottom of the conversion bar. Use a blade screwdriver and a hammer to lightly tap along the seam area. Raise the conversion bar up to the notches in the sides of the vault opening. Remove the conversion bar and drawer guide. Install new guide (found in parts bag) and the larger coin vault.

18CHECK ELECTRICAL

’REQUIREMENTS.BESURE

YOU HAVE CORRECT ELECTRl6Ai

SUPPLYAND RECOMMENDED

GROUNDINGMETHOD.

Check that you have all tools that you started with and that the shipping strap with its 3 cotterpins and plug was removed from the washer.

if entire strap is not removed, washer may vibrate and be noisy.

23.

Check the wash cycle time. Both coin- operated and non-coin operated washers have timers with a 9-minute wash in the Normal cycle. Remove the meter case top of coin operated washers to manually start the timer. Remove the rear of the console to manually operate the timer of non- coin operated washers. Start the washer and allow it to complete the Normal cycle.

24	If the	washer fails to start
	W or does not give the
proper wash cycle		time, the clutch

assembly of the coin operated can be adjusted. Remove the timer from the meter case. Adjust the clutch assembly screw clockwise, if the washer does not start after the coin slide mechanism has been fully actuated in or out. Adjust the clutch assembly screw counterclockwise if the wash segment of the Normal cycle was less than 9 minutes.

I1

. YiiiiT’mer

\ ‘5

0:

I\’

&O \ .a

<mer clutch

adjustment screw

PAGE4