INSTALLATION INSTRUCTIONS
How to install your dryer
Now that you’ve unpacked your dryer, check to be sure you have removed the parts bag from the drum. Remove the tape that holds the drum to the cabinet. Move the drum by hand to make certain all tape has been removed. Next, wipe the interior of the drum thoroughly with a damp cloth before using the dryer.
Installation
For most jobs all you need are a level, duct tape, an adjustable wrench, and a screw- driver. All the parts you need are packed in the appliance. When you take them out, place them on a cloth so you won’t lose them. Do not move appliance into the exact location until the following steps have been performed.
Installing the cord bracket
•Remove tape from the power cord and the rear panel
•Insert cord brackets into slotted holes in rear panel and secure with screws provided
NOTE: Power supply cord may be wrapped around the brackets for storage convenience when dryer is not in use.
Parts supplied with the dryer:
1 Cycle and temperature control (timer) knob
1 Push to Start button
4 Casters
2 Cord brackets
2 Screws
Casters
To install the casters, first lay dryer on its side. Use the carton to prevent damage to the dryer. Screw casters into dryer base at four corners and tighten securely. Set dryer upright. In doing so be careful that dryer does not roll away from you.
Leveling feet (Part No. 51594200) for use in permanent installations may be purchased. See the “Assistance or Service” section.
Tools needed
Cord bracket
Screw
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
7
