|
|
| INSTALLATION | INSTRUCTIONS |
| |||||||
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND | ||||||||||||
|
|
| CAREFULLY. THEY WILL SIMPLIFY THE INSTALLATION. |
| ||||||||
1. After | removing the shipping carton, | be sure to remove all | 6. Lay two carton | corner posts or other | protective material | |||||||
protective packaging | materials such | as tape and shipping | (such as a throw | rug) on the floor; then | lay the unit on either | |||||||
pads. | Waxy residue | from protective | shipping | material | of its | sides | on | the corner posts. The corner posts will | ||||
may | be removed | from compactor with | a mild | solution of | protect | the | finish of the | compactor | and the floor. See | |||
liquid | household | cleaner and water. |
|
|
| Figure | 7. NOTE: | Do not | truck or handle by console. |
2.Your compactor is designed for recessed installation. A six (6) inch (15cm) clearance from the right edge of the drawer front is desirable for added convenience in bag removal. Also allow
COMPACTOR I
WALL OR
OTHER
OBJECTS
FIGURE 7
Remove the cardboard shipping pad located on the bottom. See Figure 7. Stand compactor upright.
7.A grounded receptacle should be located 18” (45.7 cm) (min.) from the floor and in the center of the opening. See Figure 8.
(5fJYcmj ’ | ’ 6” |
| (15cml |
FIGURE2 | ’ |
3.The compactor’s overall dimensions are: Height
T-
I |
|
f |
4.Remove drawer as shown:
a.Grip handle and raise front of drawer until it clears stops. See Figure 4.
b.Grasp side ridges of the drawer and lift drawer out. See Figure 5.
7l?-lT
18” (45.7 cm) MIN.
IF-V
FIGURE8
8.Before moving the compactor into position, measure the cabinet opening as shown in Figure 9. To determine if height adjustment is required, see steps 9 and 10 below.
FIGURE9
9.The rear wheels of your compactor are preset for a minimum cabinet opening of 34” (86.4 cm) (position A). To adjust for higher openings, tilt the compactor to one side and support with a corner post or a screwdriver handle.
CAUTION: Use care so that the compactor does not drop on your hand.
10.To adjust the height, remove screw from position “A”in Figure 70. Move the rear wheel and screw to position “B or C”:
FIGURE4FIGURE5
5.Remove any materials that are shipped in the drawer. Some models have a literature storage compartment located inside the front panel. See Figure 6. DO NOT REMOVE THE BAG.
A
3Yt:
FIGURE 10
Repeat for other rear wheel.
2 | 4152821 |