Befote | you | start.. . | Important: | |||||
|
|
|
|
|
|
| Observe all governing codes and | |
Proper | installation | is your | responsibility. | ordinances. | ||||
Make | sure you | have | everything | for | Failure to meet governing codes and | |||
correct | installation. | It is the responsibility | ordinances | could lead to tire or | ||||
of the | installer | to comply | with | the | electrical | shock. | ||
installation clearances specified on the |
|
| ||||||
model/serial rating | plate. | The |
|
|
| |||
model/serial rating plate is found on the |
|
| ||||||
bottom | of the | cooktop. |
|
|
|
| ||
|
|
|
|
|
| 30” (76.2 cm) min. cabinet width | ||
|
|
|
|
|
| above 30” (76.2 cm) cooktop | ||
|
|
|
|
|
| 36” (91.4 cm) mln. cabinet wldth | ||
|
|
|
|
| 36” (91.4 cm) cooktop. |
|
|
|
| clearances, | see |
|
|
|
|
|
|
| Note: |
|
|
|
|
| min. clearance |
|
|
|
| |||
| upper | cabinet |
|
|
|
| ||
| to | countertop |
|
|
|
| ||
|
|
|
| I~~~kh |
|
|
| - |
Do Not | seal |
|
|
|
| ++cm) |
| |
|
|
|
|
|
|
| ||
cooktop | to |
|
|
|
|
|
|
|
countertop. |
|
|
|
|
|
|
| |
|
|
|
|
| locate | electrical | ||
|
|
|
|
| supply | junction | ||
| 25” | (63.5 | cm) | box | on | Boor | or | |
| countertop | depth | rear | wall at | least | |||
|
|
|
|
| ret;29 | cm) |
| |
| 24” | (61 | cm) lower |
|
|
|
| |
| cabinet |
| depth |
|
|
|
|
|
| \ |
|
|
|
|
|
|
|
|
Installation | above | wall oven. | counte*opA |
|
|
|
|
| I I | |
The cutout dimensions required for the / |
|
|
|
|
|
| ||||
cooktop and the dimensions for the |
|
|
|
|
|
|
| |||
cabinets and clearances from cabinets |
|
|
|
|
|
|
| |||
are as shown in these Installation |
|
|
|
|
|
|
| |||
Instructions. However see the oven |
|
|
|
|
|
|
| |||
Installation | I structions,“Undercounter |
|
|
|
|
|
|
| ||
installation’? | Fection, | for further | details on | *Note: | 24” | (64 cm) | min. clearance | if | ||
the proper | mounting | of the |
| bottom | of | wood | or | metal | cabinet | is |
combination | of the oven and cooktop. | protected | by not | less than | 1LV (0.06 | cm) | ||||
|
|
|
| flame | retardant | millboard | covered |
| ||
|
|
|
| wlth not less than No. 28 MSG sheet | ||||||
|
|
|
| steel, 0.015” (0.04 cm) stalnless steel, | ||||||
|
|
|
| or 0.024” (0.06 cm) aluminum or |
| |||||
|
|
|
| 0.020” | (0.05 cm) | copper. |
|
| ||
|
|
|
| 30” (76.2 cm) min. clearance between | ||||||
|
|
|
| top of cooking platform and bottom | ||||||
|
|
|
| of an | unprotected |
| wood | or metal |
| |
|
|
|
| cabinet. |
|
|
|
|
|
| 30” | (76.2 cm) | wtdth |
|
|
| 36” | (91.4~m) | width |
| I |
| (_ |
|
| _I | |
Cooktop Dimensions | ’ |
|
|
|
|
1” (53 cm) depth
Cooktop installed over oven installation: Only certain specified
Ovens approved for this type installation will have an approval label located on top of the oven. If you do not find this label, contact your dealer or refer to the
30” (76.2 cm) or 36” (91.4 cm) min. base cabinet is required. If cabinet has a drawer, a
Check location where cooktop will be installed. The location should be away from strong draft areas, such as windows, doors and strong heating vents or fans. The cooktop should be located for convenient use in the kitchen.
When installing cooktop over a built- under oven, Do Not fasten
It is the customer’s responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 - latest edition**, or CSA Standards
Injury Hazard
To eliminate the risk of burns or fire, avoid installing cabinet storage above the cooking surface. If cabinets are already installed, reduce the hazard of reaching over a heated cooking surface by installing a range hood.
The range hood should extend a minimum of 5 inches (12.7 cm) out from the bottom of the cabinets.
Reaching over a heated cooking surface could result in a serious burn.
Copies of the standards listed may be obtained from:
l * National Fire Protection Association
Batterymarch Park
Quincy Massachusetts 02269
l ** Canadian Standard Association 178 Rexdale Boulevard
Etoblcoke (foronto), Ontario M9W 1R3
Cutout Dimensions
New installations - Follow minimum dimensions given.
Replacement |
|
| |||
installations | - Be sure | - ‘\ | |||
that front | edge of | ||||
cooktop | is at | least | ‘\ | ||
(3.8 cm) | back from | ‘\\,. | |||
front | edge | of | countertop. | “x,,, |
Opening Width:
30” (76.2 cm) cooktop -
36” (91.4 cm) cooktop - 35- l/2” (90.2 cm)
Tools needed for fnstaIIatiron:
Countertop | opening | \ | / | ||
dimensions | that | are shown | \ | ||
|
|
| |||
must be used. Dimensions |
| ||||
shown provide | minimum |
| (19 | cm) | |
clearances, |
|
|
|
| Minimum distance to |
|
|
|
|
| nearest left side and rear |
Panel A |
|
|
|
| combustible surface |
|
|
|
| above countertop |