Quick reference guide | Chart |
PROGRAM SELECTION BUTTON
Push “Programs” button (repeatedly) until the indicator of the required program lights up (see “Table of programs” below).
START/RESUME BUTTON
Push this button to start the selected program: the indicator lights up and goes off at the end of the program. When the door is opened during a washing cycle, the cycle is temporarely paused: the Start indicator blinking. To restart the cycle close the door and push Start button again.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
CANCEL/OFF BUTTON
Push this button to switch off the control panel. If pressed when a program is running it cancels the program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it drains any possible liquids from dishwasher (1 minute process).
If the indicator flashes repeatedly, see page 6 - chapter ”What to do if ...”.
| Table of programs | Deter- | Consumption | ||||
|
|
|
|
|
|
| |
P | Programs |
| Loading instructions | gent | Litres | kWh | Minutes 1) |
|
| ||||||
1 |
| cold | Crockery to be washed later. | — | 5.0 | 0.02 | 10 |
2 | Quickwash | 40°C | Lightly soiled crockery, with no dried- | X | 13.0 | 0.70 | 30 |
on food. | |||||||
3 | Eco 2) | 50°C | Normally soiled crockery. | X | 15.0 | 1.05 | 150 |
4 | Intensive | 70°C | Recommended program for heavily |
|
|
|
|
soiled crockery, especially suitable for | X | 15.0 | 1.50 | 140 | |||
|
|
| pans and saucepans. |
|
|
|
|
5 | Half Load | 50°C | Ideal for washing a half load of lightly or | X | 13.0 | 1.00 | 130 |
normally soiled crockery. | |||||||
1) | Program data obtained in conformity with European standard EN 50242, obtained under normal conditions |
|
|
| (without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible |
|
|
| with sensor programs as a result of the appliance’s automatic calibration system. |
|
|
2) | Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for |
|
|
| detailed information on the EN/Standard loading comparison test and other tests, contact the following address: | ADP 3315 | 5019 396 01990 |
| “nk_customer@whirlpool.com”. |
GB
