UNDERCOUNTER START-UP GUIDE

UNDERCOUNTER START-UP GUIDE

Before using your dishwasher, remove all packaging materials. Read this entire Use and Care Guide. You will find important safety information and useful operating tips.

Using YourNewDishwasher

Tip Over Hazard

Do not use dishwasher until completely installed.

Do not push down on open door.

Doing so can result in serious injury or cuts.

Electrical Shock Hazard

Electrically ground dishwasher.

Connect ground wire to green ground connector in terminal box.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Scrape large food soil and hard items (toothpicks or bones) from dishes.

2.Properly load the dishwasher. (See “Dishwasher Loading.”) Make sure nothing prevents the spray arm(s) from spinning freely.

3.Add detergent and check the rinse aid dispenser. Add rinse aid if needed. (See “Dishwasher Use.”)

4.Push door firmly closed. The door latches automatically. Run hot water at the sink nearest your dishwasher until the water is hot. (See “Dishwasher Efficiency Tips.”) Turn off water.

5.Select a drying option.

NOTE: Use No Heat Dry for the Rinse Only cycle.

6.For Series 840 and 850: Press the desired cycle and option selections. (See “Dishwasher Use.”) Turn the cycle control knob to the desired cycle to start.

Stopping YourDishwasher

You can stop your dishwasher anytime during a cycle.

1.Open the door slightly.

2.Wait for the spraying action to stop. Then open the door all the way, if needed.

3.Close the door to continue the cycle.

OR

1.Turn the cycle control knob slowly clockwise until you hear water draining. Let the dishwasher drain completely.

2.Open the door.

3.Turn the cycle control knob to Off.

7

Page 7
Image 7
Whirlpool 810 Undercounter Start-Up Guide, Using YourNewDishwasher, Stopping YourDishwasher, Do not push down on open door