Cleaning Method:
■Stainless Steel Cleaner & Polish Part Number 31462 (not included): See “Assistance or Service” section to order.
■Liquid detergent or
■Vinegar for hard water spots.
COOKTOP CONTROLS
Do not use steel wool, abrasive cleansers or oven cleaner.
Do not soak knobs.
When replacing knobs, make sure knobs are in the Off position.
On some models, do not remove seals under knobs.
Cleaning Method:
■Soap and water or dishwasher: Pull knobs straight away from control panel to remove.
PORCELAIN-COATED GRATES AND CAPS
Food spills containing acids, such as vinegar and tomato, should be cleaned as soon as the cooktop, grates and caps are cool. These spills may affect the finish.
To avoid chipping, do not bang grates and caps against each other or hard surfaces such as cast iron cookware.
Do not reassemble caps on burners while wet.
Cleaning Method:
■Nonabrasive plastic scrubbing pad and mildly abrasive cleanser: Clean as soon as cooktop, grates and caps are cool.
■Dishwasher (grates only, not caps): Use the most aggressive cycle.
■Gas Grate & Drip Pan Cleaner Part Number 31617 (not included): See “Assistance or Service” section to order.
CONTROL PANEL
Do not use abrasive cleaners,
Cleaning Method:
■Glass cleaner and soft cloth or sponge: Apply glass cleaner to soft cloth or sponge, not directly on panel.
■All Purpose Appliance Cleaner Part Number 31662 (not included): See “Assistance or Service” section to order.
SURFACE BURNERS AND ELECTRONIC IGNITER
Surface Burners
See “Sealed Surface Burners” section.
Electronic Igniter
Cleaning Method:
■Clean the stainless steel igniter washer using a nonabrasive scouring pad. Clean ceramic post with a cotton swab:
All Purpose Appliance Cleaner Part Number 31662 (not included): See “Assistance or Service” section to order.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate |
| Surface burner flames are uneven, yellow and/or noisy |
■Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
■Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
■Are the burner caps and heads positioned properly? See “Sealed Surface Burners” section.
■Is propane gas being used?
The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
Surface burner makes popping noises
■Is the burner wet? Let it dry.
Continuous sparking of Igniter
■Is a cross draft drawing the flame away from the igniter? This is normal when a cross draft is present.
■Is the power supply cord properly grounded/polarized? See “Electrical Requirements” section.
■Is the burner cap and head positioned properly? See “Sealed Surface Burners” section.
8
