4.Once the drawer is fully engaged on both sides, slide the drawer back into the closed position. A slight push may be needed to move the drawer stop notch past the drawer glides.
Warming Drawer
(on some models)
Remove all items from inside the warming drawer, and allow the unit to cool completely before attempting to remove the drawer.
To Remove:
1.Open drawer to its full open position.
2.Locate the black
A
A. Tab
3.Press the tab down on the right side, and lift tab up on the left side at the same time, then pull drawer out another inch.
4.Holding the drawer by its sides, slowly pull it all the way out.
To Replace:
1.Align the drawer glides with the receiving guides.
2.Push drawer in all the way.
3.Gently open and close the drawer to ensure it is seated properly on the slides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
■Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
■Are the burner ports clogged?
See “Sealed Surface Burners” section.
■On models with caps, are the burner caps positioned properly?
See “Sealed Surface Burners” section.
■Is propane gas being used?
The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
Surface burner makes popping noises
■Is the burner wet? Let it dry.
Excessive heat around cookware on cooktop
■Is the cookware the proper size?
Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.
Cooktop cooking results not what expected
■Is the proper cookware being used? See “Cookware” section.
■Is the control knob set to the proper heat level? See “Cooktop Controls” section.
■Is the appliance level?
Level the appliance. See the Installation Instructions.
Oven will not operate
■Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the electronic oven control set correctly? See “Electronic Oven Controls” section.
■On some models, is the Control Lock set? See “Control Lock” section.
Oven burner flames are yellow or noisy
■Is propane gas being used?
The appliance may have been converted improperly. Contact a service technician or see “Assistance or Service” section.
Cooling fan runs during baking, broiling or cleaning
■It is normal for the fan to automatically run while the oven is in use to cool the electronic control.
18
