To operate air conditioner with remote control
POWER
ON/OFF
AutoCool
CoolTurbo
Fan Only | High |
| FAN |
| SPEED |
Power Saver | Low |
NOTE: Two AA batteries (not included) power the remote control. Replace batteries after six months of use, or when the remote control starts to lose power. Be sure to install batteries with correct polarity.
To select the mode: Press the AutoCool, Cool, Fan Only, or Power Saver button. When air conditioner is operating in AutoCool mode, fan speed is adjusted automatically. When air conditioner is operating in Fan Only mode, fan speed is automatically set at Turbo. When air conditioner is operating in Cool or Power Saver mode, you can adjust the fan speed.
AutoCool
Cool
Fan Only
Power Saver
Turbo
Temp / Time
Timer
To select the fan speed (in Cool or
Power Saver mode only): Press the | High |
FAN | |
SPEED | |
Turbo, High or Low button. | Low |
To set Timer for a 1 to 24 hour delay
until air conditioner turns on (airTimer conditioner must be in OFF mode):
To turn the air conditioner on or off: | POWER |
Press the POWER ON/OFF button. | ON/OFF |
| |
To raise the temperature: Press |
|
the▲button. Each time you press or hold |
|
the▲button, the temperature will go up |
|
1° until it reaches 86°F (30°C). | Temp / Time |
To lower the temperature: Press the▼button. Each time you press or hold the▼button, the temperature will drop 1° until it reaches 64°F (18°C).
NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.
1.Press the Timer button.
2.Press the▲button to change delay time (1 to 24 hours).
3.Press the Timer button again or wait 10 seconds.
To set Timer for a 1 to 24 hour delay until air conditioner turns off (air conditioner must be in ON mode):
1.Press the Timer button.
2.Press the▲button to change delay time (1 to 24 hours).
3.Press the Timer button again or wait 10 seconds.
6