Whirlpool AD35DSS0 manual Troubleshooting, Cleaning theDehumidifier, Exterior, Water Bucket

Models: AD35DSS0

1 16
Download 16 pages 43.42 Kb
Page 8
Image 8
Cleaning theDehumidifier

Cleaning theDehumidifier

Exterior

NOTE: Have an authorized service technician clean and service the interior coils of your product annually.

1.Turn off dehumidifier.

2.Dust front grille and side panels with a soft brush or the dusting attachment of your vacuum cleaner.

Water Bucket

Every few weeks, rinse the inside of the water bucket with a mild detergent to avoid growth of mold, mildew and bacteria.

Water Level Float

The dehumidifier has an Empty/Adjust Bucket light and a water level float. The bucket must be properly aligned for the water level float and Empty/Adjust Bucket light to work.

NOTE: Be sure float is snapped in place.

A

B

A. Water level float

B. Bucket

TROUBLESHOOTING

Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.

Dehumidifier will not run

Is the dehumidifier turned on? Turn on dehumidifier.

ExteriorWARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Is the power cord plugged into a grounded 3 prong outlet? Plug into a grounded 3 prong outlet. See “Electrical Requirements.”

Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. See “Electrical Requirements.”

Is bucket installed properly? Reinstall bucket so that it fits all the way into the dehumidifier.

Does bucket need to be emptied? Empty bucket.

Is water level float in place? Remove bucket. Make sure float is snapped in place. Reinstall bucket.

Ice forms on coils

Model AD25B dehumidifiers do not have an automatic deicer. See model and serial number label for model number. If ice forms on coils, unplug dehumidifier until ice melts and room temperature rises.

All models, except AD25B, have an automatic deicer that will shut off the compressor and allow the fan to run. This reduces the ice buildup on the coils. The compressor will cycle back on when the deicer senses the correct operating temperature.

Dehumidifier runs but does not dehumidify

Do you have model AD25D? Units with this model number have a deicer that will shut off the compressor and allow the fan to run. When the deicer senses the correct operating temperature, the compressor will cycle back on.

Do you have control type 2 or 3? Units with these control types have a deicer that will shut off the compressor and allow the fan to run. When the deicer senses the correct operating temperature, the compressor will cycle back on.

Do you have control type 3? If you have selected Continuous Run, the dehumidifier will run continuously. If the humidity level is low, little or no water may be collected.

The filter (on some models) is dirty or obstructed by debris. Clean the filter.

Air coming from dehumidifier is warm

Dehumidifier will put out warm air under normal operating conditions.

8

Page 8
Image 8
Whirlpool AD35DSS0 manual Troubleshooting, Cleaning theDehumidifier, Exterior, Water Bucket, Water Level Float