Whirlpool ADP 451 manual Water Connection, Water Outlet

WARNING!	Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
		for personal safety:
	Check	with a qualified electrician or service representative if you are in doubt whether the
		DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
	appliance	is properly earthed.
		DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE EARTHING
	Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
		CONNECTION FROM THE POWER CORD.
	please have a qualified electrician to install a proper outlet.

Water Connection

	Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
	that it is fastened tightly in place.
	If the water pipes are new or have not been used for an extended period of time, let the
	water run to make sure that the water is clear. This precaution is needed to avoid the
	risk of the water inlet to be blocked and damage the appliance.
	The water supply to the appliance can also be connected to the household hot water
	line (such as, central system, heating system),as long as it does not exceed a
	temperature of 60 C. In this case, the wash cycle time will be shortened by about 15
	minutes and the wash efficiency slightly reduced.
	The connection must be made to the hot water line following the same procedures as
	described in the section for the connection to the cold water line.
WARNING!	In order to avoid that there is more water staying in the inlet hose, please close
	the hydrant after using.(Not applicable to appliances without aqua-stop.)

Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending or crimping. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height between 40 and 100cm and must not be immersed in water.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure that the water inlet hose is not kinked or squashed.

17