Whirlpool ADP 6600 SL user manual Manual abstract

Manual abstract:

g. oil used for frying) or candle wax. If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off! If regeneration salt is to be added, immediately start a wash programme in order to eliminate any residual salt (rinsing alone is not sufficient). Sometimes even though the regeneration salt container has been filled, the corresponding indicator lamp (if fitted) will light up during the first wash cycle after filling with salt. • • • • If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem: The dishwasher is not working: • Is the plug properly inserted in the wall socket? • Is there a power failure? • Is the dishwasher switched on? • Has the Start button been pressed? • Has the delayed start timer been set (if fitted)? • Is the water supply tap on? • Is the flow of water obstructed by impurities? If so, close the water supply tap, detach the water hose and clean the filter. Then re-connect the water hose to the tap and open the water tap once again. • Are the filters clogged? (See “Care and maintenance” chapter in the user instructions). • Is the door closed properly? • Is a fault indicated? (The Start indicator lamp flashes). Start the programme again from the beginning: press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button.

• Your full address and telephone number. Please read the user instructions carefully. Dishwasher loading instructions UPPER RACK LOWER RACK

Half Load / Multizone Depending on the model, rack features may vary (see “Upper and lower rack” description)..

Your user manual

WHIRLPOOL ADP 6600 SL

Powered by TCPDF (www.tcpdf.org)