Whirlpool AWT 2040 manual Adding Detergent and Additives, Close the Door and Select the Programme

GB

ENERGY AND WATER CONSUMPTION DATA

	Programme	Temperature			Load		Water			Energy	Programme
												time
			(°C)		(kg)			(l)		(kWh)		(min)
	Cotton	90		5.0		72			1.80		115
	Cotton	60		5.0		72			1.15		115
	Coloured	60		2.0		66			0.80		100
	Coloured	40		2.0		66			0.40		100
Quick Wash + 1/2 Load		40		2.5		57			0.55		85
Synthetics + 1/2 Load		30		1.0		55			0.30		70
	Delicate	40		1.5		70			0.65		55
	Wool	40		1.0		70			0.55		45

Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual consumption may vary in comparison with the values specified in the table, because of differences in supply water pressure and temperature, the load and the type of wash.

ADDING DETERGENT AND ADDITIVES

Pour the detergent and additives into the respective compartments as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and starch

• Bleach

• Stain removers

• Anti-scale agents (water hardness 4)

Important Note:

•Do not fill beyond the “MAX” level mark.

•For programme with prewash: do not use liquid detergent.

•For programmes without prewash from cold to 40° C, it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry.

CLOSE THE DOOR AND SELECT THE PROGRAMME

1.Turn the programme selector knob clockwise to the desired programme.

2.Turn the temperature knob to the required temperature.

SELECT ANY DESIRED OPTION

“Half Load” button

•Reduces the water consumption in the “Cotton” and “Synthetics” programmes especially during the rinse.

•Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).

•Not suitable for high temperature programmes.

“No Spin”

•It excludes the spin function from the programme.

PROGRAMME START

Open the water inlet tap and select the desidered spin speed, turning the spin speed and On/ Off knob to the desidered position (the indicated spin speed or “No Spin”) .The pilot lamp lights up.

DOOR LOCK

During the running programme, the door cannot be opened. The door locks automatically in all programmes.

If the programme is stopped or if an electrical power failure occurs, the door unlocks automatically after about 1 minute.

PROGRAMME END

•The programme selector knob is at “STOP”.

1.Turn the spin speed knob to the Off position “”. The pilot light goes out.

2.Cancel the options by pressing the appropriate buttons.

3.Turn the water supply tap off.

4.Wait for the door to unlock (about 1 minute).

5.Open the door and the drum flaps and unload the machine.

SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START

1.Turn the spin speed knob to the Off position “” to switch off the appliance. The pilot light goes out.

2.Select the new programme, temperature and options.

3.Turn the spin speed knob to the desidered spin speed to switch on the appliance. The pilot light lights.

TO STOP, RESET A PROGRAMME BEFORE THE END

1.Turn the spin speed knob to the Off position “” to switch off the appliance. The pilot light goes out.

2.Set the programme selector on “Drain”.

3.Turn the spin speed knob to the desidered spin speed to start the “Drain” programme. Only open the door when the programme selector is at “STOP” and

the door is unlocked (after approximately 1 minute).

5019 100 01026