WASHER USE

WASHER USE

UnderstandingWasherCycles

When the washer lid is closed and the Cycle Control knob is set to a number or cycle and pulled out, the washer fills (to the selected load size) before agitation and timing start. The washer begins agitating immediately after filling; agitation occurs with the washer lid down.

During agitation, the agitator creates a continuous rollover action (on some models) that provides a thorough cleaning of the wash load.

After agitation starts, the Cycle Control knob turns clockwise until it points to an OFF area and the cycle ends.

NOTE: The washer pauses briefly throughout each cycle. These pauses are normal for washer operation.

WASHRINSE

1. Fill

1. Fill

2. Wash

2. Rinse

selected time

 

3. Drain

3. Drain

No agitation

No agitation

4. Spin

4. Spin-Spray rinse

5. Spin

The Casual/Permanent Press

6. Off

cycle partially drains, fills,

 

agitates briefly, and drains.

 

Loading

For rated load capacity, refer to the model and serial label/plate, located on your washer as shown in “Parts and Features.”

Loading suggestions

For these suggested full-sized loads, set the LOAD SIZE selector to the highest load size setting.

SUPER CAPACITY PLUS WASHERS

Heavy Work Clothes

 

3

pair pants

1 coverall

3

shirts

1 overall

4

pair jeans

 

 

 

Delicates

 

3 camisoles

2 bras

1

quilted robe

2 nighties

4 slips

1 baby’s dress

4 panties

 

 

 

Towels

 

10 bath towels

14 washcloths

10 hand towels

1 bath mat

 

 

Mixed Load

 

3 double sheets

2 shirts

4 pillowcases

2 blouses

8

T-shirts

8 handkerchiefs

6

pair shorts

 

EXTRA LARGE CAPACITY WASHERS

Heavy Work Clothes

 

2 pair pants

3 pair jeans

3 shirts

1 coverall

 

 

Delicates

 

3 camisoles

2 bras

4 slips

2 nighties

4 panties

 

 

 

Towels

 

8 bath towels

10 washcloths

8 hand towels

1 bath mat

 

 

Mixed Load

 

2 double sheets or

6 pair shorts

1 king size sheet

2 shirts

4 pillowcases

2 blouses

6 T-shirts

6 handkerchiefs

NormalSounds

Your new washer may make sounds your old one didn’t. Because the sounds might be unfamiliar, you may be concerned about them. These sounds are normal.

During washing

When you select a small load size setting, your washer has a lower water level. This can cause a clicking sound from the upper part of the agitator.

During drain

If water is drained quickly from your washer (depending on your installation), you may hear air being pulled through the pump during the end of draining.

After drain and before spin

When the cycle changes from draining to spinning, you may hear gears engaging.

5

Page 5
Image 5
Whirlpool Compact Washe manual Washer Use, UnderstandingWasherCycles, NormalSounds, Washrinse, Loading suggestions