Install properly.. . 1. Allow
%”
(.2 cm) space on each srde and at top for
ease of installation.
2. The refrigerator back can be flush against the
wall.
3. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
d.. . . . *
Level refrigerator-freezer.. . Right to Raise;
Left to Lower
Refrigerator
Power Cord
Recommended
Grounding Method
I, Remove base grille [see page 8). A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused
2. To raise front, turn each screw to the right electrrcal supply is required. It is recommended that
3. To lower front, turn each screw to the left. a separate circuit serving only this applrance
4. Check with level. be provided.
Do not use an extension cord. Use a receptacle
which cannot be turned off wlth a switch or pull
chain. See individual electrical requirements and
grounding instruction sheet in your literature
package.
Remove sales labels.. . Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
I. Rub brrskly with thumb to make a ball then remove.
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart warm water) before
removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean your refrigerator before using it. See cleaning
instructions on page 9
4