Install properly.. .
T
c
I, Allow % inch (1.25 cm) space on each side and at the top of the refrigerator for ease of installation.
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider
3.The refrigerator back can be flush against the wall.
Level refrigerator-freezer.. .
Use Screwdriver
Right to Raise;
Left to Lower
I, Remove base grille (see page 7).
2.To raise front, turn each screw to the right
3.To lower front, turn each screw to the left,
4.Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with liquid hand dishwashing detergent before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
..:.. i-/,,I”i,.. ;<a::.il ,_ lul*$$%;,~r.,iv : i:
Clean it.. .
Clean your refrigerator before using it.
See cleaning instruction on page 11,
* | i ,(rl | .I | ‘I | ‘i | c.,*, |
Plug it in...
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It IS recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
