Install properly.. . | Remove sales labels.. . |
| Remove the Consumer Buy Guide label, tape and |
| any inside labels before using the refrigerator. |
| To remove any remaining glue: |
| I. Rub briskly with thumb to make a ball then remove |
| OR |
| 2 Soak area with dishwashing detergent solution (1 |
| teaspoon detergent in 1 quart warm water] before |
| removing glue as described In step 1. |
| DO ,NOT USErubbing alcohol or flammable or |
| toxic solvents, such as acetone, gasoline, car- |
| bon tetrachloride, etc. These can damage the |
| material. |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- |
| STRUCTION LABELS INSIDE YOUR REFRIGERATOR. |
| Do not remove the Tech Sheet fastened under |
| the refrigerator at the front. |
| .a.=’1’41w4tmewi:.w*,.r*. * |
1.Allow % inch (1.25 cm] space on each side and at the top of the refrigerator for ease of installation
2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.
3.The refrigerator back can be flush against the wall
Clean it.. .
Clean | your | refrrgerator |
|
|
before | using | it. - | , |
|
See cleaning | Instructions | .. | ||
|
|
|
| |
Plug it in...
Level refrigerator-freezer...
Levelli
1.Remove base grille [see page 7).
2.To raise front, turn each leg to the left.
3.To lower front, turn each leg to the rrght
4.Check wrth level
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See Individual electrical require- ments and groundrng instruction sheet in your liter- ature package.
