Before you plug it in
Before using Your freezer, You are personally
responsible for making sure that it...
l is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.
l is connected only to the right kind of outlet, with the right electric supply and grounding (see below).
l is used only for jobs expected of home freezers.
l is not near an oven, radiator or other heat source.
Install Properly. ..
II 3 inches | 3 inches |
1.Check the strength of the floor. It should hold weight of fully loaded freezer.
2.Allow at least 3 inches (7.5 cm] air space on all sides of freezer and 2 inches [5 cm) at back. Leave room at top for lid to open all the way.
3.It should not be necessary to remove the lid
during installation. If, for any reason, the hinges
need adjustment, see Your authorized WHIRLPOOL dealer.
4.Do not cover the freezer with items such as blankets, sheets, tablecloths, etc.
Remove Sales label...
Remove the Consumer Buy Guide label before using the freezer. Remove any left over glue with rubbing alcohol.
Note: DO NOT REMOVE the Care and Ser- vice label on the inside lid. This permanent
label provides immediate information should it be needed. Do not remove Tech
Sheet permanently attached to back of cabinet.
Clean It...
Clean your freezer before using it. See clean- ing instructions on page 5.
2
l is properly maintained.
l is in a dry sheltered area.
l is used in an area where the room tempera- ture will not exceed
l is not run where there are explosive fumes.
l is not used by children or others who may not understand how it should be used.
l is not loaded with food before it has time to get properly cold.
level Chest Freezer.. .
from end to end and front to back so that the lid will seal properly
Install the Battery...
You will find the freezer key and a
The Temperature Alarm will sound a continu- ous tone if the Temperature Alarm Switch is in the ON or TEST position. Move the switch to OFF until the freezer is cold. Then move if to ON.
Install the Defrost Drain Cover...
Packed inside the freezer is the Defrost Drain
Cover and a hose adapter. Keep the hose adapter in a handy place to use when defrost- ing the freezer. Install the Defrost Drain Cover over the opening in the lower left, front corner of
your freezer.
*‘$3.
Plug It In...
grounding plu
Recommended Grounding Method
A 120 Volt, 60 Hz., AC only, 15 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appli-
ance be provided. The receptacle should not be controlled by a wall switch or pull chain.
Attach retaining clip over power cord plug
from the literature package inside your freezer. Do not use an extenslon cord.
