Using your freezer
Setting the Cold Control...
1.Insert a coin In the slot of the Cold Control to turn It
2.Turn control to Number 3 This setting will maln-
taln zero zone temperatures under normal op- erating conditions
Adjusting Cold Control...
l Turn control to higher number for colder temperatures
l Turn to lower number for less cold temperatures.
Key Eject lock.. .
The key eject lock can help reduce the hazard of child entrapment.
To lock or unlock the freezer you must hold the key in the lock while turning. The lock is spring loaded so the key cannot be left in the lock.
lfthe key is lost, contact your WHIRLPOOL dealer for a reolacement.
Exterior Signal Light...
automatically warns of any unexpected power failure.
If the signal light is not glowing, immediately check:
0 for power interruption,
l the power plug; it may be disconnected from the outlet,
l the warning light; it may be burned out.
Cooling Freezer First. ..
l Allow freezer to cool 6 to 8 hours before filling with frozen food.
l let it cool overnight before adding large amount of unfrozen food.
Note: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times the freezer lid is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
The outside of your freezer may feel warm. This is normal. The freezer’s design and main function is to remove heat from packages and air space inside the freezer. This heat is transferred to the room air so the walls of the freezer may be warm.
To replace burned out signal light:
1.Unplug power cord from outlet.
2.Carefully snap out light cover and assembly
with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer.
3.Unplug burned out signal light and replace with a new one. Signal light can be ordered from your Whirlpool dealer.
4.Then, snap light assembly into place.
5.Plug cord into outlet.
Replacing Interior light. ..
1.Unplug freezer.
2.Replace bulb with a 15watt appliance bulb.
3.Plug in freezer.
Sliding Baskets...
can be moved from side to side when load- ing or unloading food below it. The basket also ccin be lifted out of the freezer completely.
