Using your freezer
Setting the temperature control...
I, Insert a coin in the slot of the Temperature Control to turn it.
2.Turn control to Number 3. This setting is designed to maintain the temperature at or near 0°F ( ~ 178”CJ under normal operating conditions.
The sliding basket...
Can be moved from side to side or removed when loading or unloading food below It
To remove:
Lift basket out
To replace:
Lower basket into Dlace
The key eject lock...
can help reduce the hazard of child entrapment
Adjusting the temperature control...
I. Turn control to higher number for colder temper- atures.
2 Turn to lower number for less cold temperatures.
Cooling freezer first...
I, Allow freezer to cool 6 to 8 hours before filling with frozen food.
2.Let it cool overnight before adding large amount of unfrozen food.
NOTE: When freezer is first started the compressor will run constantly until the cabinet is cooled. It may take up fo 6 to 8 hours or longer, depending on rmrn tem- perature and the number of times the freezer lid is opened.
After the cabinet is cooled the compressor will turn on and off as needed to keep freezer at proper temperature.
To lock or unlock the freezer you must hold the key in the lock while turning The lock is spring loaded so the key cannot be left in the lock
If the key IS lost, contact your WHIRLPOOL dealer for a replacement. Always give the com- plete model and serial number of your freezer
when requesting a replacement key.
The signal light...
automatically warns of any unexpected power failure.
If the signal light is not glowing, immediately check: l for power interruption,
l for an unplugged power cord, l for a burned out signal light.
To replace:
1.Unplug power cord from outlet.
2.Carefully snap out light cover and assembly with a screwdriver by inserting it under the end of metal edge of the light. Be careful not to chip finish on freezer.
3.Unplug burned out signal light and replace with a new one. Signal light can be ordered from your WHIRLPOOL dealer.
4.Then, snap light assembly into place.
5.Plug power cord into outlet.