Install properly.. .
1.Allow 3 inches (7.5 cm] between overhead cab- inets and the refrigerator top.
2.Allow at least an inch (2.5 cm) between the refrig- erator condenser and the wall.
3.Allow l/2 inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.
Remove sales labels.. .
Remove the Consumer Buy Guide label and other insrde labels before using the refrigerator. Any glue left can be taken off with rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigerator at the front.
Clean it.. .
Clean your refrigerator before using it. See clean- ing instructions on page 7.
Level refrigerator-freezer...
I. Keep the 4 bolts that hold refrigerator and shipping crate. They are the levelling legs.
2.Screw these bolts all the way into bolt holes at the bottom corners of refrigerator.
3.Adjust each leg until the refrigerator won’t rock. Slide refrigerator into place.
4.Adjust front legs to level the refrigerator
5.Check with level.
Plug it in...
grounding type wall receptacle
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only, 15 or 20 ampere fused electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a receptacle which cannot be turned off with a switch or pull chain. See individual electrical requirements and
grounding instruction sheet in your literature package.
4
