Install properly.. .
Allow 3 Inches (7.5 cm] between overhead cab- inets and the refrigerator top.
Allow at least an tnch (2 5 cm] between the refrrg- erator condenser and the wall.
Allow 1z Inch (1 25 cm) on each side of the re- frigerator for ease of rnstallatron
If the refrigerator is to be against a wall, you mrght want to leave enough space so the door can be opened wider
| *v | -n.T%*i | /, | |||
Level |
| . ” ~~ | ||||
Right | to | Raise; |
|
|
|
|
Left | to Lower | Leveling | screw |
| ||
Use Screwdriver to Adjust
1.To raise front, turn each screw to the rrght
2.To lower front, turn each screw to the left
3.Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.
To remove any remaining glue:
I. Rub briskly with thumb to make a ball then remove
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water] before removing glue as descrrbed in step 1
DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-
bon tetmchloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigemtor at the front.
Clean your refrigerator before using it See clean- ing instructions on page 8.
Plug it in...
Refri&ator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit serving only this applrance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off wlth a switch or pull chain. See individual electrical require- ments and grounding instruction sheet in your liter- ature package.
4
