Whirlpool ET22MM Install properly, Level refrigerator-freezer, Remove sales labels, Clean it

Install properly.. . .

1.Allow 1/2inch (1.25 cm] space on each side and at

the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator back can be flush against the wall.

#,li’ll.: ,I

Level refrigerator-freezer.. .

Righl to Raise;

Lett to Lower

I. Remove base grille (see page 89

2.To raise front, turn each screw to the right.

3.To lower front, turn each screw to the left.

4.Check with level.

Remove sales labels.. .

Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.

To remove any remaining glue:

1.Rub briskly with thumb to make a ball then remove.

OR

2.Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) before

removing glue as described in step 1.

DO NOT USE rubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car-

bon tetmchioride, etc. These can damage the material.

NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under

the refrigerator at the front.

.I-,I ,- ,a,IT. . ?,

Clean it.. .

Clean your refrigerator ’ before using it.

See cleaning instructions on page 8,

Plug	it	in...
J-prong	grounding
type wall		receptacle,	.i

3-prong

grounding plug

A

I

Refrigerator

Power Cord

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re-

quired. It is recommended that a separate circuit

serving only this appliance be provided.

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch

or pull chain. See individual electrical require-

ments and grounding instruction sheet in your liter- ature package.