Manuals / Whirlpool / Kitchen Appliance / Refrigerator

Whirlpool ET25DM warranty Changing the light bulbs, Removing the base grille

Models: ET25DM

1 24

Download 24 pages 29.99 Kb

Page 13

Changing the light bulbs

Changing the light bulbs

Electrical Shock Hazard

Before removing a light bulb, either unplug the refrigerator or disconnect the electricity leading to the refrigerator at the main power supply.

Failure to do so could result in electrical shock or personal injury.

To change the refrigerator light:

1.Disconnect refrigerator from power supply.

2.Reach behind the Control Panel to remove bulb.

3.Replace with a 40-wan appliance bulb.

4.Reconnect refrigerator to power supply.

To change freezer light:

1.Disconnect refrigerator from power supply.

2.Grasp the top and bottom of the light shield.

3.Squeeze and pull light shield out.

4.Replace with a 25wan appliance bulb.

5.Snap light shield into place.

6.Reconnect refrigerator to power supply.

NOTE: Not all commercial appliance bulbs will fit your refrigerator. Be sure to replace a bulb with one of the same size and shape.

Removing the base grille

To remove the grille:

1.Open refrigerator door.

2.Pull base grille forward to release the support tabs from the metal clips.

3.Do not remove Tech Sheet fastened behind the grille.

To replace the grille:

1.Line up grille support tabs with metal clips.

2.Push firmly to snap into place.

3.Close refrigerator door.

See cleaning instructions for defrost pan and condenser coils on page 16.

13

Image 13

Whirlpool ET25DM warranty Changing the light bulbs, Removing the base grille

Contents

Refrigerator5 Using Your Refrigerator7 Parts And Features Before Using Yourfl of 4a UseAndCare \I-saA Note To You Your safety is important to usThank you for buying a Whirlpool appliance is toll-free,24 hours a dayHelp us help you Important Safety InstructionsControl panel Parts And Featuresswitch Exterior moistureCleaning it Before Using Your RefrigeratorInstalling it properly Plugging it in1.Remove base grille. See page Leveling it2.To raise front, turn screw clockwise 3.To lower front, turn screw counterclockwiseSetting the controls Using Your RefrigeratorTemperature controls In This Section Pa*PageAdjusting the door bins settingsChanging the control Adjusting the refrigerator shelves Adjusting the bin/shelf glidesRemoving the meat drawer and cover Removing the crispers and crisper cover Adjusting the crisper humidity controlRemoving the freezer shelf Using the ice cube trays ETZ~DKIRaising the ice compartment door Factory-installedon ET25DM, optional on ET25DK Using the automatic ice makerRemoving the base grille Changing the light bulbsUnderstanding the sounds you may hear Reversing the door swingSaving energy Slight hum, soft hissCaring For Your Refrigerator Cleaning your refrigeratorIn This Section PagePage care Vacation and movingLong vacations Short vacationsFood Storage Guide Power interruptionsStoring fresh food QuestionsButter or margarine Storing frozen foodCheese LeftoversFreezer food storage chart 1. Before calling for assistance If You Need Assistance Or Service2. If you need assistance 3. If you need service4.If you need FSP replace- ment parts Page Page Refrigerator WarrantyWHIRLPOOL”