Removing the crispers and crisper cover

To	remove	the	crispers:		out	to	the	stop,
1. Slide the crisper straight out to the stop.						lift	the	front
1. Slide the crisper straight out to the stop.					and	pull		again.
2.	Lii the front.				and	pull		again.
2.	Lii the front.
3.	Slide out	the	rest of the	way.
4.	Replace	in reverse order.

To remove the cover:

1.Push up glass insert from the bottom, then slide it out with both hands.

2.Lii front of cover frame.

3.Pull cover frame up and out.

4.Remove metal cover support.

To replace the cover:

1.Replace metal cover support on wall supports in front section of cabinet.

2.Fi back corner of cover frame into notch supports on walls of refrigerator, then lower front onto metal cover support.

3.Slide back of glass insert into cover frame. Then lower front to level position.

Remove the glare inset-L Lift front of cover frame, then the back.

Adjusting the crisper humidity control

You can control the amount of humidity in the moisture-sealed crispers.

The control can be adjusted to any setting between LOW and HIGH.

LOW (open) lets moist air out of the crisper for best storage of fruits and vegetables with skins.

HIGH (closed) keeps moist air in the crisper for best storage of fresh, leafy vegetables.

lf cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

To remove ice:

1.Hold tray at both ends.

2.Twist slightly.