Install properly.. . 1. Allow 3 Inches (7.5 cm] between overhead cab-
rnets and the refrigerator top.
2. Allow at least an Inch (2.5 cm] between the refrig-
erator condenser and the wall.
3. Allow % inch (1.25 cm) on each side of the re
frigerator for ease of installation
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
sl,,.TxLm .I r. .-II il ..,,I..
,-intw*, ir* - :. 5, c 1 i L - . :
Level refrigerator-freezer.. . Right to Raise;
Left to Lower Levelling screw
Use Screwdriver
to Adjust
1 To raise front, turn each screw to the right
2 To lower front. turn each screw to the left
3
Check wtth level
Remove sales labels.. . Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
I. Rub briskly with thumb to make a ball then remove.
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasollne, car-
bon tetmchloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the retrigerator at the front.
Clean it.. . Clean your refrigerator before using it. See clean-
ing instructions on page
a.
Plug it in...Rettigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extenslon cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments
and
grounding instruction sheet in your liter-
ature package.
4