Adjusting

the shelves...

1. First, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lift front.
4. Slide the rest of the way out.

Replacing Shelf:

I. Fit back of shelf on top of guides with wire stops
on the bottom of gurdes
2. Lrft front, slide shelf In until It clears gurde stops.
Shelf Guide
Removing crispers and crisper cover.. .

Removing the Crispers:

1 Slide crisper straight out to stop, lift front, then slrde
Lift the Front, Then the Back.
the rest of the way out
2. Replace in the reverse order

Removing Cover:

1 Loft front and remove the cover support
2. Loft out cover by pullrng up and out.

Replacing Cover:

1 Fit back of cover into notch supports on walls of
refrigerator, then lower front Into place
2. Replace cover support wrth the long tab towards
the front.

Note:

If support needs adjustment, turn
base right to lower, or left to ratse
Pull out to stop.
ront and Pull Again.

Ice cube trays...

If cubes are not used, they may shrink. The movrng

lo remove Ice:

l
Hold tray at both ends
. Slightly twist
cold air starts a slow evaporation The longer cubes
are stored, the smaller they get

Optional automatic ice maker.. .

Arm to Stop Ice Maker
If you have the automatic Ice maker accessory or
plan to add one later [Part No. ECKMF-83). there are a
few things you will want to know
l
The ON/OFF lever
IS
a wire signal arm.
Down...for making Ice automa-ically,
Up...to shut off the Ice maker.
l
Shake the bin occasronally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They ~111 break apart easily
l
You will hear water running when ice maker IS
working. You’ll hear ice fall into the bin Don’t let
these sounds bother you.
l
The ice maker will not operate until the freezer
IS
cold enough to make Ice. This can take overnight.
l
Because of new plumbing connections. the first
Ice may be discolored or off-flavored Discard the
first few batches of ice.
l
If ice
IS
not being made fast enough and more ice
IS needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward A.
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push It all the way In and lower the arm to the ON
position.
l
If cubes are stated too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes in the ice btn can also
become smaller by evaporation
l
The ice maker water supply

should not be Soft-

ened water.

The chemicals could damage the ice
maker molds.
6