Install properly... | Remove sales labels... |
| ||
| Remove the Consumer Buy Guide label and any | |||
| inside labels before using the freezer. | |||
| To remove any remaining glue: |
| ||
| 1. Rub briskly with thumb to make a ball, then | |||
| remove. |
|
|
|
| OR |
|
|
|
| 2. Soak area with dishwashing detergent solution (1 | |||
| teaspoon detergent | in | 1 quart | warm water) be- |
| fore removing glue | as | described | in step I, |
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachioride, etc. These can damage the material.
NOTE: DO NOT REMOVE the Tech Sheet fas- tened under the treezer at the front.
Check the strength of the floor. It should hold the weight of a fully loaded freezer.
Pick a safe place, indoors, away from in- flammables such as gasoline.
Allow 3 inches [ 7.5 cm) air space on top of freezer for proper ventilation.
Allow at least an inch (2.5 cm) between the freezer condenser, on the back of the unit, and the wall.
Allow % inch (1.25 cm] on each side of the freezer for ease of installation.
If the freezer is to be against a wall, you might want to leave extra space on the hinge side so the door can be opened wider
Level freezer...
so the door will stay > open at any position.
Start ad)ustment with the door hinge side.
1, Slide the freezer into place,
2.Adjust front legs to level the freezer - To raise front, turn legs clockwise.
3.Check with level.
4.After freezer is fully loaded, recheck with level
Clean it...
Clean your freezer befo using It. See cleaning instructions on page 6.
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle which cannot be turned off wtth a switch or pull chain. Do not use an extension cord.
Attach retaining clip over power cord plug from literature package inside the freezer,
