Cleaning your freezer, Changing the light bulb

Changing the light bulb...

Light Shield

WARNING: To avoid possible shocks, first unplug

freezer or turn off electricity leading to freezer at the main power supply.

1 Remove the light shield from the side of the control panel. Depress the bock of the shield to release the tabs, then pull away

2 Replace bulb with a 40.watt applrance bulb.

3 Replace the light shreld Insert the shteld tabs in the slots, then press the shield to snap into place

4 Plug In power cord or switch on electricity

To replace:

1 Posrtion bock of trivet on the rear wall supports 2 Lower front into place

You con help your freezer use less electricity

l Check door gasket and level freezer to assure o good door seal

l Clean the condenser COIISregularly

l Keep dooropenrngs to a mrnrmum Remove several Items at one time Keep contents organized to elim note searchrng

l Fill to capacity Follow recommended procedures for freezrng foods See pages 8 and 9

l Set Temperature Control to provide temperatures oround 0 F ( 17 8 C) There IS no need to store foods below 0 F

l Keep door locked to ensure door closure

lDo not let frost build up to more than ’ inch (6 mm) thick Effrcrency IS reduced

l Keep Power Saving Control on OFF when humrdlty IS low

Thusfreezer is a No-Frost model and defrosts autorr ~~trcally Complete cleanrng, however, should be done at least once a year

To clean:

1 Turn Temperature Control to OFF

2 Unplug power cord

3 Take out all food

Note: Wrap frozen foods and packages In several layers of newspaper and cover with a blanket Food will stay frozen for several hours

4 Remove shelves and trivet

5 Clean freezer according to the following directions

After cleaning:

1 Replace shelves and trivet

2 Plug in power cord

3 See drrectrons for “Setting the Temperature Control:’ page 5

WARNING: When moving the freezer, wipe up any water that may have spilled from the defrost pan. Spilled water can cause slipping and injury.