Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial. This setting will maintain zero zone temperatures under normal operating conditions.
Note: When | freezer | is first started | the | compressor |
| |||||
will | run Iconstantly | until the | cabinet | is | cooled. | It | ||||
may | take | up | to | 6 to | 8 hours | or longer, | depending |
| ||
on | loon‘) | temperature | and | the | number | of times |
| |||
the free,!er door | is opened. |
|
|
|
|
| ||||
After t?e CaPinet is cooled the compressor will turn on ‘and off as needed to keep freezer at proper temperature.
Adjusting Cold Control...
l Turn control to higher number for colder temperatures.
l Turn to lower number for less cold temperatures.
Cooling Freezer First.. .
l Allow freezer to cool 6 to 8 hours before filling with frozen food.
l Let it cool overnight before adding large amounts of unfrozen food.
lFrost will form on the shelves. It will form first and be heavier on the top shelves.
I===POWER SAVING CONTROL
‘5AV ES
POWERMOISTURE
OFF ON
The Power Saving Control...
operc:tes electric heaters. These heaters help prevent moisture from forming on the outside of the freezer when humidity is high.
lUse th!i: OFF setting when humidity is low to save electrlN:ity.
l Use ON only if moisture forms on outside of freezer.
Exterior Signal light .. .
automatically | warns of any unexpected | power | To replace | burned | out | signal | light: |
| |
failure. |
|
| 1. | Unplljg | power | cord | from | outlet. |
|
|
|
|
| ||||||
|
|
| 2. | Remove | base | grille. | See | page | 4. |
If the signal light is not glowing, immediately check:
l for power interruption,
l the power cord; it may be disconnected from the outlet,
l the signal light; it may be burned out.
3.Unplu;d burned out light and replace with one of sari>>> wattage and size. Signal light can be orderli>d from your WHIRLPOOL dealer, Part No. 530584.
4.Replace base grille. See page 4.
5.Plug F ‘ower cord into outlet.
3
