Removing the bottom trivet ...
To | remove: |
|
| |
1. | Lift front | of trivet | out of supports. | Lift the Front, |
2. | Pull out. |
|
| |
|
| Then Pull Out. | ||
To replace:
1.Position bock of trivet on the rear wall supports
2.Lower front into place.
The key eject lock...
can help reduce the hazard of child entrapment
To lock or unlock the freezer you must hold the key In the lock while turning. The lock IS spring loaded so the key cannot be left in the lock.
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement Always give the com- plete model and serial number of your freezer
when requesting a replacement key.
The signal light...
automatically warns of any unexpected power failure.
Signal Light
If the signal light is not glowing, immediately check:
l for power interruption,
l For on unplugged power cord, l for Q burned out signal light.
Energy saving tips...
You can help your freezer use less electrlclty
l Check door gasket and level freezer to assure a good door seal
l Clean the condenser COIISregularly
l Keep door openings to a mlnlmum Remove several e items at one time Keep cor;tents organized to ellrnl-
nate searching
l FIII to capaclty Follow recommended procedures for freezing foods See pages 0 and 9
To replace burned out signal light: 1, Unplug power cord from outlet.
2.Open the freezer door.
3.Unplug burned out light and replace with one of some wattage and size. Signal light can be ordered from your WHIRLPOOL dealer,
Part No. 1103680
4.Close freezer door and plug power cord into outlet.
l Set Temperature Control to provide temperatures around 0°F ( ~ 17.8 “C). There is no need to store foods below 0°F
l Keep door locked to ensure door closure
lDo not let frost build up to more than ::: Inch (6 mm] thick Efficiency IS reduced
l Keep Power Saving Control on OFF when humldlty IS low
6
